grounding conductor

英 [ˈɡraʊndɪŋ kənˈdʌktə(r)] 美 [ˈɡraʊndɪŋ kənˈdʌktər]

网络  接地导体; 接地线; 接地导线

电力



双语例句

  1. Connecting with exterior grounding conductor is an effective measure to decrease ground grid grounding impedance.
    对接地阻抗测量原理进行研究,分析推导出接地阻抗计算公式。
  2. However, at least one facility used a floating delta secondary with no grounding conductor whatsoever.
    不过,至少有一个设施使用一个浮动的三角洲中学没有接地导线的话。
  3. Study on the Grounding Mode of 10 kV Single Conductor Cables on the Passenger Dedicated Lines
    客运专线10kV单芯电缆接地方式的研究
  4. Selection of the Grounding Conductor Cross Section of Neutral Point at Transformer Low-voltage Side
    变压器低压侧中性点接地导体截面的选择
  5. The reason for corrosion of the grounding steel conductor in surrounding conductive concrete is analyzed.
    分析了包覆导电混凝土钢接地体腐蚀的原因。
  6. Several improvements are put forward in ground system, which could greatly reduce the impedance of the grounding conductor and duplicate grounding resistance, enhance the balanced voltage, and the correct usage of ground-fault circuit-interrupter and safe disconnecting transformer.
    笔者提出多项改进措施,在接地、接零系统中采用大幅度降低保护零线阻抗和重复接地电阻值以及加强等电位措施,正确使用漏电开关及安全隔离变压器等方法。
  7. In homogeneous soil, TGR and the influence of the buried depth of the grounding conductor on TGR decrease with increasing ground conductivity.
    对均一土壤,TGR随大地电导率的增大而减小,大地电导率越大,TGR对接地体的埋深越不敏感。
  8. In order to conveniently analyze the influence of measurement error on grounding grids diagnosis results, the corrosion of a branch of a grounding grid is described by four degrees according to the extend of corrosion of the conductor.
    为分析测量误差对接地网故障诊断结果的影响,将导体的腐蚀程度分为4个等级。
  9. This paper adopts the method of auxiliary charge. To determine electric dipoles and the force between grounding conductor-ball and point charge. It can also determine the force between infinite surface conductor and point charge.
    本文采用辅助电荷方法,求解电偶极子电场,接地导体球与点电荷之间作用力,以及无限大平面导体和点电荷之间作用力。
  10. The Area of Section Choosing and Set-up of the Grounding Protection conductor for the Metallic Cable Tray System
    金属电缆桥架接地线的截面选择及设置
  11. The locale grounding conductor is the huge pedestal of the turbine. This method also has reference value for other locale equipments in DCS.
    把汽轮机巨大的底座作为现场良好的接地导体,对于与DCS相连的其它的现场设备也有很好的参考价值。
  12. The paper presents single point grounding of PEN conductor can prevent stray current inside building electrical equipments. Based on it, the author also analyses pole number's determination of power transfer switch between generator and normal power supply in TN system.
    阐述了在建筑物电气装置内PEN线一点接地防杂散电流危害的问题,并分析了它与TN系统内正常电源和发电机电源间转换开关极数确定的关系。
  13. Grounding of PEN Conductor in TN System and Pole Number Determination of Power Transfer Switch
    TN系统PEN线接地和电源转换开关极数的确定
  14. The EMTP is used to set up the computation model of the primary circuit of an 110 kV GIS, the very fast transient overvoltage and transient currents ( on the grounding conductor) are calculated.
    用EMTP建立了一实际110KVGIS一次系统的计算模型,并对特快速暂态过电压和接地导体上的暂态电流进行了仿真计算。
  15. Combined with field operating conditions, to measure and calculate the grounding impedance by testing the shunt function of overhead lightning conductor in a local power failure conditions.
    结合现场运行状况,在局部停电条件下,通过测试停电线路架空避雷线分流系数对地网接地阻抗进行准确测量、计算。
  16. When corrosion is severe, grounding device including grounding wire and grounding conductor may quickly get thinner or even broken, which could force the grounding resistance to increase and make those grounded equipments become inadequate grounded.
    腐蚀严重时,接地网中的接地体和接地线会变细甚至断裂,使接地电阻升高,电气设备失地。
  17. At the same time, the test method of grounding Impedance with overhead lightning conductor do not need to spend a lot of manpower and resources to unlock the overhead lightning conductor-based connection. It will save a huge production costs.
    同时,带架空避雷线进行地网接地阻抗测试不需要花费大量人力、物力来解开架空避雷线与架构的连接,将节省巨大的生产成本。
  18. The grounding material is usually good electrical conductor. The port resistance of the down lead conductor is usually in the range of m Ω, which is hard to measure in a strong electrical environment.
    接地网材料通常为电的良导体,其引下线间的端口电阻值一般在毫欧级,在强电磁环境中的测量困难。